Growcraft X3 – 330W DIY LED Grow Light Kit

4.92 out of 5
48 customer reviews
(48 customer reviews)


SKU: GC-KIT-330-X3 Category:


Growcraft Light Spectrum Options

Passive Cooling Linear Bar Design

Thin Profile – Only 1.375in Tall

Rugged T Slot Bar Design

Oversized surface area for maximum heat dissipation

Remote Power Driver Location

Lower your heat load by removing power driver outside grow area

Made In The USA – Finest quality materials and workmanship manufactured at our facility in Arlington, WA

Input Power Draw: 330W
Input Voltage Range: 90-305 VAC

120 VAC Current Draw: 2.8 Amps
208 VAC Current Draw: 1.6 Amps
240 VAC Current Draw: 1.4 Amps
277 VAC Current Draw: 1.2 Amps

Power Driver: Mean Well HLG-320H-48B
AC Power Cord Length: 6.5 ft
DC Extension Cord Length: 7 ft
Dimming Range: 10-100%

Light Engine Efficacy: 3.26 μmole/J – 2.9 μmole/J
Power Driver Efficiency: 95% @ 230 VAC
Full System Efficacy: 3.1 μmole/J – 2.76 μmole/J

Light Bar LED Information:
Samsung 3000K White LEDs – 140 per Light Bar
Samsung 5000K White LEDs – 140 per Light Bar
660nm Deep Red LEDs – 15 per Light  Bar

Warranty: 3-Year Component Warranty

Operating Temperature Range: 41°F – 95°F | 5°C – 35°C
Operating Humidity Range: 10 – 90% Non-Condensing
Generated Heat Load: 1,126 BTU/Hour

Water Protection: Currently, the Growcraft has no protective coating against direct moisture exposure. If moisture accumulates near the LEDs damage may occur. Make sure to point any sprays downward and away from the LEDs.

Use of VOC (Volatile Organic Compounds):
DO NOT USE VOCs, like burning sulfur, near any Growcraft. This can damage the LEDs beyond repair and is NOT covered by our warranty.

Minimum Head Space Above Fixture: 6 in
Recommended Hanging Height:
12-24 in
Recommended Grow Room Ambient Air Temperature: 85°F | 29.5°C
Coverage Area: 2 x 4 ft
Start Slow – Growcraft lights have VERY high light output and unless your plants are already acclimated to high light intensity, it is best to start slow with the light hanging high and possibly also dimmed. Then monitor plant reaction over a few days and slowly adjust as needed.

Fixture Dimensions: 42.5 in x 19.5 in x 1.375 in
Fixture Weight: 17 Lbs


PAR Intensity Maps

6 in Hanging Height

2’x4′ Canopy Area – 6 in Hanging Height

Average PPFD – 1274 µmol/(m2s)

12 in Hanging Height

2’x4′ Canopy Area – 12 in Hanging Height

Average PPFD – 1079 µmol/(m2s)

18 in Hanging Height

2’x4′ Canopy Area – 18 in Hanging Height

Average PPFD – 894 µmol/(m2s)

24 in Hanging Height

2’x4′ Canopy Area – 24 in Hanging Height

Average PPFD – 845 µmol/(m2s)

DIY Kit Includes:

2 x Growcraft DIY U-Frame – 2×4
2 x Growcraft DIY U-Frame Cover – 2×4
1 x Growcraft Power Distribution PCB – 2×4
3 x Growcraft 40in Heatsink
3 x Growcraft 40in LED Board
1 x M3 – 6mm Plastite PCB Screw – 5 pack
1 x M3 – 8mm Plastite PCB Screw – 25 pack
1 x M3 – 5mm Countersunk Torx Screw – 25 pack
1 x M4 – 14mm Torx Screw – 25 pack
3 x Growcraft PCB End Cover 2 Pack – ChilLED WHITE
1 x Growcraft Strain Relief Cable Gland – Black
1 x 20 AWG Red & Black Solid Core Wire Pair – 6ft
1 x 48Vdc Pigtail with 2 Pin Female Connector
1 x Push Lock 7ft Driver Extension Cable
1 x Push Lock AC Power Cord (Your Choice of AC Plug)
1 x Push-Lock Mean Well HLG-320H-48B LED Driver
1 x Push-Lock Dimmer Pot
1 x Growcraft DIY U-Frame Hole Plug
4 x Rope Ratchets

Weight & Dimensions

Weight 28.5 lbs
Dimensions 43.45 × 8.95 × 7.7 in
Choose LED Spectrum Type

Flowering Optimized/Full Cycle Spectrum, Vegetative Cycle Optimized Spectrum

Push Lock AC Power Cord

USA 120VAC – NEMA 5-15P (Standard), USA 240VAC – NEMA 6-15P, European – EU1-16P, Australia & New Zealand – AS NZ 3112

48 reviews for Growcraft X3 – 330W DIY LED Grow Light Kit

  1. 5 out of 5
    48 customer reviews

    AP (verified owner)

    I just finished installing the second one of these in my 2×8 space. I look forward to seeing the temperature readouts at the end of the week now that there are no more drivers in the space. Sad the stickers didn’t make it in there but that is not going to hurt anything!

  2. 5 out of 5
    48 customer reviews

    Zach Harkness (verified owner)

    I waited until after I finished a cycle with the light to review it and it is amazing. Seriously crushed a 4×3 space, dense beautiful nugs from top to bottom. It has also brought out a significant terpene increase from hps. I grew the same strain 3 runs in a row and this was the last. It yielded more and better quality than the hps. This light blows HIDs out of the water. Exceeded all my expectations, and I would recommend this to anyone serious about their craft. Build quality is superb and the diy is cake. Worth every penny, thanks Chilled tech.

    • Gabrielle

      Thanks so much for your review, Zach!

  3. 5 out of 5
    48 customer reviews

    Anthony (verified owner)

    I made the jump from the recommended Viparspectra for a 2×4 space to this and was amazed at the difference while using a driver with near identical specs.
    It was easy to build the DIY kit, even with never wiring anything in the past. The footprint is accurate on the website which was important for actual available space for the light to sit flush.

    1 week in and the plants are thriving. Excited to see the end result! I will be after another kit for the other side of my 2×8 soon enough.

    • Gabrielle

      Anthony, that’s amazing! Thanks for letting ChilLED know about your experience 🙂 Happy growing!

  4. 5 out of 5
    48 customer reviews

    Aaron Bomaster

    I ordered this for my 4×2 as a tester of yalls product quality. I was simply blown away the light intensity and efficiency is insane. It went together quickly and stays very cool compared to all other lights I’ve used.

    • Gabrielle

      Thanks, Aaron for the amazing review!

  5. 5 out of 5
    48 customer reviews

    Samuel Figueroa

    My plants are LOVING this beast of a light fixture!!! It’s almost too powerful, thick dense plants! Worth every single cent!!!!! ❤️ 💚 💜

    • Gabrielle

      Thank you Samuel for the review 🙂 Happy growing!!

  6. 5 out of 5
    48 customer reviews

    BT (verified owner)

    First and foremost – Customer Service was AMAZING! I initially emailed on a Sunday with a question about availability, not expecting to get a response until Monday….but nope…1 hour later I had a quick response, and immediately purchased my light! Quality of the light kit was also top notch – Light output is absolutely incredible too. I can’t speak highly enough about ChilLED as a company! Don’t waste your money with another ‘budget’ light…just do it and go with ChilLED!

    • Gabrielle

      Hello BT! Thanks for taking the time to let us know about your experience with your purchase. We strive to stand out with our customer service and we are so glad you feel this way about us.
      Happy growing!

  7. 5 out of 5
    48 customer reviews

    Michael Doak (verified owner)

    One of the best lights out there, hands down! I ran a comparison grow out of two tents with the same size light and ChilLED outperformed in size and density on the flowers. Heavy and dense is the two words which best describes my harvest. The lights will put your tent in beast mode.

    • Gabrielle

      That is amazing Michael! Thanks for letting us know about your growing experience.

  8. 5 out of 5
    48 customer reviews

    Matt Niemczura (verified owner)

    Outstanding Customer Support. Incredible Build Quality. Just an awesome company making amazing lights. Very impressed with the materials used and overall craftsmanship.

    • Gabrielle

      Thank you, Matt! We strive to leave you all impressed 🙂

Add a review

Your email address will not be published. Required fields are marked *